Garelick Outboard Transom Platform w/Telescoping Ladder

Garelick Outboard Transom Platform w/Telescoping LadderFeatures:One stainless wraparound rail and one underside support rail (both 1″ (3cm) diameter, Reversible)Durable HDPE platform is pre-drilled for easy assemblyWith 2 Step Telescoping Ladder. Overall: 18″ Wide x 19″ Deep. Height above and below platform: 11.5″.Ladder: Length deployed: 23.5″, Length stowed: 13.5″, Width: 11.25″. Platform Only: 18″ Wide x 15″ Deep x .75″ TallMounts at 10 degree angle on transomLadder Steps telescope down easilyLadder slides up and under platform for stowageFlat Poly treads for extra comfortInstructions:After determining which side of the platform is most suitable for the handrail, mount it to the platform using 2 bolts through holes in platform. Secure with 2 locknuts.Mount SS strut 22 by inserting bolt through hole and secure with locknut.Mount SS strut 11 by inserting two bolts through holes and secure with 1 locknut.Choose most suitable side of transom for mounting platform. Turn motor unit as far as possible to that side. Make a line on the transom indicating motor units full extension to that side.Position platform away from drawn line at desired mounting location, parallel to the water line, and mark 4 mounting holes through flattened ends of rails and/or struts onto the transom.Drill four marked holes with a bit compatible with selected fasteners (fasteners not provided). Hold drill perpendicular to transom when drilling.If transom is less than 2 thick, it is recommended that a backing plate be mounted on the inside of transom.NOTE: The backing plate should be made of either aluminum, marine plywood or some other suitable non-compressive material.Coat the mounting surfaces of the rails and/or struts with a marine grade adhesive/caulking compound; squeeze a small amount into mounting holes in transom. Insert selected bolts through holes and secure in position with suitable fasteners.Maintenance:Periodically check mounting hardware and re-tighten (due to normal boat operation).Regular fresh water rinsing and periodic cleaning with a mild abrasive cleaner will help retain luster and help prevent corrosion.Information sourced from Garelick Assembly Instructions for Platforms Technical DataInstallation InstructionsRetaining Strap Installation Instructions